Adaptec RAID Array

[fivefive1978]

I have an older RAID card that I'm using for secondary storage in the open-e. It's one of those Adaptec I2O cards that's built onto the motherboard.

Anyway, Open-E recognizes the card and I've been using it for some time now. However, one of the drives failed (RAID 5) and there was no indication anywhere.

Is there a way for a failed drive in the RAID array to show up in the logs or the error console or (best) an email sent?

I can see that the drive is failed in the RAID CLI interface from the console but that's the only place.

Thanks,
Ryan

[masim]

Your RAID controller is the place where you get those errors.. Also, your hardware should make some noise on a faild drive..

Open-e logs also shows RAID issues...