Problem accessing Open-E NAS 2.0 2.12
Hi, I have got an Open-E NAS 2.0 ver. 2.12 I can't access anymore.
It worked until an Array Rebuild done using the Raid Controller Setup.
Now the system goes up, the usual messages are on console, smbd starts (miscofigured
but at least it's listening on his port), but httpd fails and I can't access to the web interface.
Is there any way to obtain a console from the system, even on a serial port?
I think that this version lacks Console and Extended Tools (Ctrl-Alt-t, Ctrl-Alt-x don't work ).
I'd got 2Tbyte on it...., please help me.
Thank you in advance.
Problem accessing Open-E NAS 2.0 2.12
All our products have Console functions (see below). When rebuilding you RAID was there live data (important) existing? With NAS 2.0 there is a 2TB limit; is your RAID larger then this? Please check all hardware for errors i.e. RAM (entering the escape key after boot), motherboard and controllers. Hopefully all resources have been saved as well as your data. If you cannot access the console screen even with attaching a monitor & keyboard you might have to upload version 2.12 again. Please read the instructions carefully.
Functions:
CTRL + ALT + n
If you press the left CTRL key + the left ALT key + n, you will be asked for the new IP address and the subnet mask. The DHCP server will be shut down.
CTRL+ALT+p
If you press the left CTRL key + the left ALT key + p, the access restrictions are lifted by entering the administrator password (in addition, there is a reset to the standard https port 443).
CTRL+ALT+i
By pressing a combination of left CTRL key, left ALT key and i, you can reset the original IP address (192.168.0.220) and the subnet settings (255.255.255.0). In this process, the DHCP server support is turned on.
CTRL+ALT+t
By pressing a combination of left CTRL key, left ALT key and t, you can run Console Tools. The menu will appear, with choice of following functions: Ping, DHCP Ping, Hardware info, Memory info, Time configuration and DNS configuration.
CTRL+ALT+h
By pressing the left CTRL key, left ALT key and h, Open-E NAS will display hardware and driver information.
CTRL+ALT+x
By pressing the left CTRL key, left ALT key and x, it will display extended tools.
F1, F2 and F5
Function key F1 is available to display help information while F5 will reset the console display to default. If you press F2 key all network interface will be displayed.
Shutting down and restarting
With Ctrl + ALT + DEL the Open-E NAS host computer will be shut down, while CTRL + ALT + S shut it down completely. Please be careful with this option when users are connected.