iSCSI autofailover config error
Hello,
I want to configure the iSCSI autofailover feature in DSS v6, but after finishing all tasks (volumes, replication, network, ...) and clicking on "start" I get this error:
"Error! Network configuration is missing. Please make sure broadcast addresses are the same on all the designated network interfaces"
OK, but where should the broadcast addresses be the same? I have 6 NICs with the following IP schema:
DSS#1:
eth0 192.168.0.220 255.255.255.0
eth1 192.168.201.220 255.255.255.0
eth2 192.168.202.220 255.255.255.0
eth3 192.168.203.220 255.255.255.0
eth4 192.168.204.220 255.255.255.0
eth5 192.168.205.220 255.255.255.0
bond0 192.168.206.220 255.255.255.0 (eth3+eth4)
virt1 192.168.220.220 255.255.255.0
virt2 192.168.221.220 255.255.255.0
DSS#2:
eth0 192.168.0.221 255.255.255.0
eth1 192.168.201.221 255.255.255.0
eth2 192.168.202.221 255.255.255.0
eth3 192.168.203.221 255.255.255.0
eth4 192.168.204.221 255.255.255.0
eth5 192.168.205.221 255.255.255.0
bond0 192.168.206.221 255.255.255.0 (eth3+eth4)
virt1 192.168.220.221 255.255.255.0
virt2 192.168.221.221 255.255.255.0
And what are these "Auxiliary Connections"?
