SW RAID1 Rebuild

Hi,

iam just starting with testing Freenas Dss V6 lite . I have it installed on an QNAP NAS and sofar it works good.
I have installed two 2TB Disks as SW RAID1. Now i have taken out one drive for about 2 min and restored it than again.
I got mails notification about that probelm. So far so good.
But now i just dont find an way how to activate an rebuild of the raid.
I have searched in forum, but just didnt find anything that realy made me understand what to do.
Can anybody give me an tip what steps i have to take ?

Thanks a lot

It should be in the SW RAID feature informing of the rebuild or in a state of DEGRADED mode or it has already completed the rebuild.

Hi,

i was an bit too fast with my post.
i think i have just found the way:
- remove with extended console tools content of disk that i took out
- reboot
- then mark it in web gui as spare for md0 raid
- rebuild starts

But thanks anyway for fast reaction :-)