New user, Trying to setup a test network.
http://documents.open-e.com/Open-E_D...over_a_LAN.pdf
Attempting to setup the test network described in the pdf.
After i go the the status page,42 in pdf. I do not get the same results.
I get
Global status
Service running
inactive
Node status
inactive
Ping node group status
unknown
Individual ping node status:
IP: 192.168.2.6
ok
Failover services:
iSCSI
on
NFS off
Communication via:
eth1
unknown
bond0
unknown
Task status
[iSCSI] Vol001Mirror
running
Also the buttons do not work on failover manager
Failover manager
Info
Auxiliary network interfaces are not configured properly. Please make sure auxiliary network interfaces have unicast remote IP addresses.
start
stop
In order to delegate (switch) active server state to the passive server click the Manual failover button. This will initiate a failover event and switch the primary server to suspend mode, while the secondary server will be promoted to active mode. Please note this will stop the volume replication process.
Manual failover
Here is my config of the network.
Name
IP address DHCP Active Cable State
eth0
192.168.137.11
off
yes
cable
single
eth1
192.168.1.11
off
yes
cable
single
eth2
192.168.1.220
off
yes
n/a
bond0
eth3
192.168.2.220
off
yes
n/a
bond0
bond0
192.168.2.11
off
yes
n/a
n/a
