Hi,
Open-E DSS is starts boots & it will hanged on 59%.
What is the solution. Kindly help!
Thanks
Printable View
Hi,
Open-E DSS is starts boots & it will hanged on 59%.
What is the solution. Kindly help!
Thanks
Be sure the hardware you are using is supported: http://www.open-e.com/service-and-su...tibility-list/
If booting from USB, use a USB 2.0 device, 3.0 is not supported yet.
Dear Admin,
The system is works perfectly from last 2 months... but today my storage server was hanged & when i restart my storage server then i faced this problem.
Kindly help!
Since it has been running previously, most likely you have a problem with the boot media, or its image.
Please reinstall the OS, and restore your settings in the new install.
I thought you where trying it for the first time, sorry about that.
The system was works from last 2 months .. But today open-e was hanged & when we restart the server after that we faced issue on boot hanged on 59%.
Please see my previous reply:
Quote:
Since it has been running previously, most likely you have a problem with the boot media, or its image.
Please reinstall the OS, and restore your settings in the new install.
I thought you where trying it for the first time, sorry about that.
We already change the USB & reinstall the OS. But problem still remain.
Kindly help!
Most likely it is a hardware issue then.
Please verify all hardware is working properly.
I've seen this many times and I'm always praying on my knees when it reaches a few critical stages... 59% is one of them.
I've seen it taken about 10 or 15 minutes at 59%.
1) Might be a scan of the disks/volume / e2fsck? Look at the LEDs at the disks.. is anything happening?
2) One time I saw it hanging at (I thought 90%), only after unplugging it from the network (it had 8 network cables for failover, heartbeat, bond, etc.) it was able to boot. At 90 or 91%, the webinterface/Apache is loaded and you should be able to access it.
3) I've even seen it happen after booting with a fresh installed Open-E medium (I assume it was a disk check in that case).
I hope Open-E will make an option to press ESC during boot to actually see all the (debug) messages during boot instead of showing the Logo.