Surface Scan has stopped

Hi,

Was receiving notifications of a surface scan from both of our sans. This seems to have stopped.

Last one displayed in event viewer.

2013/02/10 23:14:19 CCISS controler /dev/cciss/c1d0 reported: Surface Analysis Pass Information, LDrv=0 Number of passes=164.

Since then nothing. I have not logged in to either of the sans for over a month and made no changes. Not sure what has happened.

Currently running 7.0up00.9101.6417 64bit .

Thanks

Jim

DSS V7 with build 7356 has newer HP drivers you are on older release, see if updating to the newer release and check if your firmware is updated on the HP controller. Also you might want to contact HP about this message.

I can update by all means. Will schedule some downtime to do this.

It wasnt the message itself I was worried about but the lack of any messages telling me it had done a surface scan. Dont understand why both sans have stopped suddenly.

Thanks

Jim