Network settings

Hello,

We use 100MHz/full duplex network ports on the switches. By default DSS only connects at half duplex which causes poor performance.
Now, duplex settings are not documented in the manual. I understand that it should be set somewhere in
<Ctrl><Alt>T, Modify driver setting, Select driver
But then there are two entries that seem possible
<Full Duplex>, setting it to 1 does not change anything, even after reboot
<Options>, a bit pattern for which the comments do not entirely fit on the screen, making any change quite risky.

So, the simple question is: How do I enable Full Duplex?

Thanks

Most default to Full and DSS LITE should be defaulting to this as well. Check in the test.log to verify. If you are using an Intel NIC then you need to set this to 2 (full).

http://www.intel.com/support/network/sb/cs-009209.htm

From Test.log:

*-----------------------------------------------------------------------------*
ethtool eth0
*-----------------------------------------------------------------------------*

Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 0
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000033 (51)
Link detected: yes