Problem with activation of DSS lite v6
I installed DSS lite v6 on an HP DL380G4 without any problems (using an USB boot device and selected hard disk installation on a separate 2GB partition), I can access the interface, create the volume groups and iscsi targets.
The only thing I cannot manage to do is activating the license. I generated a license key in my user portal and pasted it. The system asked for a reboot so I did. Afterwards, when I logon I get the option to activate over the internet or offline.
When I try to activate online I get the following error message:
Cannot open XML data file: /currver/activation.xml
When I try to generate the hardware stamp I get the following error:
Could not create preactivation file. Please contact support.
I have installed version 6.0up04.8401.3530 64bit
Any suggestions would be welcome :)
Thanks!
DSS V6 LITE Activation Problem
Hi!
Last week I bought a DSS V6 Full 8TB and a DSS V6 Lite 6TB.
To install the full version on my actual NAS, I decided to install the Lite version on an old hardware to backup my main NAS before I install DSS there.
Everything works fine until the Activation of the DSS V6 Lite.
I get the same problems as Jurgen_VDP in post #1.
online activation -> "Cannot open XML data file: /currver/activation.xml"
offline activation -> "Could not create preactivation file. Please contact support."
I hope someone could help me to get this working.
Thanks in advance, Pascal
BTW: Sorry for my bad english.