webgui with blank screen too
I have a similar problem with the Open-E DSS lite just like HofMar. The installation on an USB-Stick, the configuration of the IP-Address, Pings from outside/inside and the console don't cause any trouble, but if I try to connect on the webgui with https, it only shows a blank screes after accepting the certificat.
This occurs on Windows as well as on Linux with all kinds of Browsers (Firefox, IE, Opera, etc.)
Additonal Question with same problem
Hy,
i have the same problem with the webgui.
My question is now, if this can come while i have only 200Mb RAM
in the computer. During the startup looks all fine and i can also
ping from the dss-computer to the other computers in the network
(Normaly ping, No DHCP-Ping). From other computers i can also
ping the DSS.
Best regards,
Roland
same here with installation on IDE2CF Adapter SSD
I have the same problem. Console ist running fine. 192.168.0.220 ist listed in the routers connected devices. Ping works fine. When calling http or https the system ist asking to accept the Certificate. After that, blank page with no Source code at all is displayed.
I have installed NOT in VM but on a IDE2CF Converter, as Salve Device on primary IDE Controller.