Printable View
Example message
"Lost access to volume 496befed-1c79c817-6beb-001ec9b60619 (san-lun-100) due to connectivity issues. Recovery attempt is in progress and outcome will be reported shortly."
VMware states this is due to the heartbeat not being received for a period of 16 seconds.
This only happens with FC volumes iscsi are ok, any help would be appreciated. I looked at the tests.log but it means nothing to me
GAJH
Look at the dmesg.2 log and look for the Qlogic info to see if there are any errors, nothing much will be in the test.log for the FC HBA.
Thanks Todd had a look but means nothing to me
Can you dump the log here so I can look at it - only from starting from the raid controller down.
Cant find how to upload tried pasting the text but it is too much
Just copy the text from the log from the starting point of the RAID controller down to the bottom.
still too long can i just email it to you
Send them in from your user portal and send the whole logs we will be looking out for them. Or use pre-sales@open-e.com but faster if you use your user portal.
I sent these in and have never had a response:(
what was your ticket # ?
Hi I am still struggling to resolve this issue, I only get the problem when I am moving/migrating virtual computers to the open-e FC volumes, doing the same to Sanmelody Datacore FC volumes on the same esx server works fine. Tired different server hardware/fibre cards and 2 x brocade sikworm switches. I have raised with support and so far nothing possitive.
I have tried ESX 3.5 and 4, vm powered on or off still the same. Any one else experianced this let me know
Quote:
Originally Posted by gharding
Hi gharding ,
any luck on this one , our customer has a similar problem.
1 x Open-E SAN and 4 x ESXi 4
We've been true:
1) small update for FC driver
2) enable chache on the RAID controller
3) swap all HDDs for SAS only
4) Update Open-E to the latest
5) replace FC HBA
VMware has checked their ESX boxes and IBM done the FC switches checks - all pointing to our SAN.
http://postimage.org/image/4qndbp8k/
We have changed the Fibre Channel Volume to WT when assigning it to a FC Group in DSS, that has stop the disconnect errors in vmware :) but has shown a perfromance decrease but we think that is down to the raid card that we will be replacing. Fingers crossed. Let me know how you get on if you try this.
Thanks Gavin
Well I think it is finally resolved, we swapped the HP and Dell raid card with an LSI Megaraid 9620-8i and set the settings as per open-e performance document for LSI and even with WT unchecked on the Volume we are getting no errors and very good performance.:D
Unfortunatley we are still experiencing the problems, wider if we need to upgrade to 8GB fibre, anyone else had this issue
I have found this article and it seems that there may be an issue with vmware ESX4 and storage servers not just open-e. http://communities.vmware.com/thread/228916