Hello,
I have tried that, it gives same problem.. Today I'm going to try NFS on windows 2008 32bit and compare the performance.
Any suggestion, please feel free..
Thanks,
Type: Posts; User: habibalby
Hello,
I have tried that, it gives same problem.. Today I'm going to try NFS on windows 2008 32bit and compare the performance.
Any suggestion, please feel free..
Thanks,
I will try that.. Thanks for this suggestion. will reply to you once it's done..
Hi,
I have enabled it and rebooted the DSS, still same issue. Copy started at 5.5 MB/s and ended up on 1.7 MB/s :(
hello,
I'm using 6.0up50.8401.4786 32bit. I have tried these settings as I have found them in one of the thread in this forum. But nothing helps. Jumbo frames enabled in the ESX vSwitch. I will...
Hi,
I have DSS installed on a Virtual Machine running under ESX 4.1. 200 GB VMDK is presented via the ESX DataStore. 1 Target and 2 Vol Group created and presented to the ESX as an iSCSI Target....
DSS Nic Teaming Configuration is attached.
http://www.filesend.net/download.php?f=e7d4d29750c1c006b03d41e7c9fdabf8
Hello,
No, I don't want failover between primary and secondary DSS. I need the nic to be teamed and I will be having nic redundancy on physical switch level. Then, inside the ESX, I will configure...
I have DSS with two interfaces, currently ESX pointed to the eth0 only. I want to simulate the nic teaming/redundancy if one nic goes down, the other should takes over and iSCSI initiator won't be...
i have configured it this way, But I don't know is it correct or not. But I see its working;
http://forum.open-e.com/showthread.php?p=9819#post9819
Hello,
I have tested the below in my VMWare WorkStation and I have seen it it's working, but is it the way how it should be configured?
Here's its;
I have added two interfaces, eth0 and...
However, this doesn't fulfill my requirement.
What is stated in this document is to connect two hosts in the same sub-network. My requirement is to have nic teaming in each server and I can...
hello,
link is invalid.
Thanks,
Hello,
Thanks for your reply, but my subnet is only one and I don't have another subnet. Can I set the bounding/Teaming on the same subnet?
CONFIGURATION SEVERAL NETWORK ADAPTERS IN THE SAME...
Hello,
I have installed Open-e on hp server that has two NICs, I plugged each NIC to different switch on the same vLAN. How can I create NIC Teaming? To avoid nic failure/switch failure.
Thanks,
Hello,
I'm a VCP and I really want to test the Open-e:;
It's Setup
It's Configuration
It's Networking
It's Failover in clustering / Replication
It's performance
Please if you have those...