Visit Open-E website

Search:

Type: Posts; User: forall

Search: Search took 0.00 seconds.

  1. Remove target from cluster and remove replication task

    Hi,

    I have problem when I remove target from cluster but I have error messages on the both node: Failover cluster could not perform requested operation (error code #HARCE03).
    How I can remove...
  2. Replies
    5
    Views
    3,034

    Hi, I have the same situation but I try...

    Hi,

    I have the same situation but I try install Open-E as virtual machine under XenServer.. It's possible to run DSS as virtual machine under XenServer, any chance to support that option?
  3. Thread: IPMI ip address

    by forall
    Replies
    1
    Views
    2,231

    IPMI ip address

    Can I check ipmi ip address from Web GUI DSS?
  4. Thread: Throughput

    by forall
    Replies
    6
    Views
    5,752

    Hi, I read this article...

    Hi,
    I read this article http://blog.open-e.com/bonding-versus-mpio-explained/ and as I good understood, when I have 2x1GbE NIC on server and storage DSS and run multipathing on my XenServer I should...
  5. Thread: Throughput

    by forall
    Replies
    6
    Views
    5,752

    Hi Gr-R, MPIO, you have mean multipathing,...

    Hi Gr-R,

    MPIO, you have mean multipathing, without any port link aggregation?
  6. Thread: Throughput

    by forall
    Replies
    6
    Views
    5,752

    Throughput

    Hi,

    How to measure throughput between open-e and xenserver to check that lacp works correct. I configured bond (802.3ad) interface on open-e and XenServer (active-active),but under virtual machine...
  7. Replies
    1
    Views
    2,680

    DSS v7 - Active/Passive

    Hi,

    I have 2 servers where I installed the latest DSS v7 version. Now I want to configure active/passive, but when I press button to start cluster I have information about cluster state:

    ...
Results 1 to 7 of 8