Visit Open-E website

Search:

Type: Posts; User: mjp

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    3,664

    Central Management or External Management Agents

    Is there any way to get a central management system for those of us with multiple clusters deployed? Even with a single cluster deployment with 2 units, it would be nice to be able to manage...
  2. On "1" up54, if I try to Start the cluster (this...

    On "1" up54, if I try to Start the cluster (this is the secondary node right now):
    Internal error occurred
    Failover cluster could not perform requested operation (error code #HT24).
    You may also...
  3. Cluster stuck in Starting status after upgrading to up53

    Been running through stepped upgrades on a few of the clusters (some of them from up12 to up54 without issue)..

    One cluster, however, is stuck (for reference, we'll refer to one host as "1" and...
  4. We already have the 2x DSSv7 Unlimited capacity...

    We already have the 2x DSSv7 Unlimited capacity licenses ready for those boxes :) But, we'll keep it in mind for the next cluster
  5. Thanks - it looks like after discussion, we're...

    Thanks - it looks like after discussion, we're going to be installing a new cluster with 48TB SSDs to replace that older cluster, so, we'll just be doing some VMware storage migration.
  6. Increasing storage volume for replicated iSCSI Active Passive for VMware

    We're running out of storage on one of our replicated clusters (Active/Passive), and will be adding 16x1TB SSDs (8 per node). We'll have to make this a separate VD in the RAID controller (Intel/LSI)....
  7. I've finally had the chance - I created tickets...

    I've finally had the chance - I created tickets for 2 different clusters that have speed and performance issues in similar setups.
  8. Sounds good, I'll call tomorrow to make sure this...

    Sounds good, I'll call tomorrow to make sure this will work... Would love not to have to do more vMotions than necessary.
  9. Write back won't be enabled on the controllers -...

    Write back won't be enabled on the controllers - they're setup for FastPath (LSI)... That requires:
    Write Policy: Write Through
    IO Policy: Direct IO
    Read Policy: No Read Ahead
    Disk Cache Policy:...
  10. I guess I should be clear - this will not really...

    I guess I should be clear - this will not really be an "upgrade" in the sense that I'm upgrading the version.. We'll be pulling the drives out since they're all spindles, and getting replaced with...
  11. Thanks, Todd - I think I was accounting for that...

    Thanks, Todd - I think I was accounting for that by doing the direct IP connection? I'm just not sure if I can setup the iSCSI volume on the v7 unit with all failover settings in place and still work...
  12. I didn't run a Write test before getting the...

    I didn't run a Write test before getting the volumes in place, but, the Read test was pulling back about 4-500MB before I moved the VM load to it.. Now it's reading about 250MB on the read.
    (This is...
  13. Will this work for no downtime upgrade from DSS v6 to DSS v7 with iSCSI Failover?

    I was wondering if this would work to do a no downtime upgrade from DSS v6 to DSS v7 with Failover currently in use.. It's running the last release v6 in an iSCSI Failover configuration (for VMware...
  14. Slow performance (or unexpected rates) with 10Gb and SSD storage arrays

    We have a couple of the following clusters setup:

    Open-E DSS v7 (latest build) in Active/Passive iSCSI for VMware
    Intel R2224GZ4GC
    1 cluster pair uses RMS25CB080 (SAS 6Gb) controllers with 16x...
  15. Replies
    74
    Views
    80,396

    Would love to get the information as well, Thanks!

    Would love to get the information as well, Thanks!
  16. Just wanted to see if anyone had any thoughts on...

    Just wanted to see if anyone had any thoughts on this...
  17. Just watched the video again - I remember seeing...

    Just watched the video again - I remember seeing it before because the audio/video is a little out of sync, hehe.

    It's good to know that updates can be done either way (primary or secondary...
  18. Thanks, Todd - should've known to check the video...

    Thanks, Todd - should've known to check the video library :p
  19. Proper way to upgrade to B6156 from B5845 in iSCSI HA config?

    What's the best way to proceed to upgrade a production HA iSCSI failover cluster running B5845?

    We can't take the iSCSI targets down...

    Do we upgrade the secondary unit first, manually failover...
  20. Well - I went ahead and just marked the drive...

    Well - I went ahead and just marked the drive offline - rebuild to the hotspare began automatically and progress is being shown in place of the "Hotspare" text.

    However, I can't seem to click the...
  21. The hotspare is already there - but there are...

    The hotspare is already there - but there are media errors on some of the drives that are part of the array. We want to use the DSS GUI to force a rebuild onto the hotspare. What's the proper method...
  22. Hardware RAID - force rebuild to hotspare - proper way

    What's the proper method to force a rebuild to a hotspare drive? We have drives which are reporting media/other errors, and want to RMA them.

    In the GUI (we are using Intel/LSI controllers), we...
  23. Failover between two Datacenters with Open-E and VMware Site Recovery Manager

    We are looking to get a secondary data center location in a different state. The link between the primary and secondary site is a 100Mb connection with about 7ms latency between the two. This will be...
  24. Replies
    2
    Views
    3,276

    Thanks for the reply :) I'm guessing someone...

    Thanks for the reply :)

    I'm guessing someone is logged in right now (I see a "User logged in from 127.0.0.1")?

    I'm going to get some sleep and if need be, reinitate the remote support session...
  25. Replies
    2
    Views
    3,276

    Remote Support Connection doesn't stay open

    Not sure what's going on, but the remote support connection doesn't seem to remain open. It will randomly disconnect with "Remote Support: Remote support connection problem has occured. Remote...
Results 1 to 25 of 33
Page 1 of 2 1 2