Aso, in that link says:
Select Repair File System on LV (Logical Volumes)
Please note: when running file system repair the volumes will be unmounted and the shares not available for use.
This...
Type: Posts; User: mikep
Aso, in that link says:
Select Repair File System on LV (Logical Volumes)
Please note: when running file system repair the volumes will be unmounted and the shares not available for use.
This...
Looking again at the logs I have this error, that was causisng VMs on that hypervisor went to RO:
Dec 8 09:53:56 [kern.info] kernel: [978191.413459] iscsi-scst: ***ERROR***: Connection with...
Thanks Al-S.
Regards
Hello, we had some VM going to RO today, I've searched logs and I can found this:
Thu 08Dec2011 (tz=-60)
09:56:15.28017000 JNI: ArcAdapter.cpp: Line #: 5021
JNI:...
[root@hypervisor7 ~]# service iptables stop
Expurgar reglas del cortafuegos: [ OK ]
Configuración de cadenas a la política ACCEPT: filter [ OK ]
Descargando...
Hello, no bonds, vlan yes, but access mode, same config than the other Hypervisors and switch ports that are currently running ok.
Regards
I also checked SAN logs and the only thing I can find about ip I try to connect from is I can see ip in arp -nv output. No other log show anything about this ip. Even tried to add to de ACL, without...
Sorry, I forgot to mention I can ping the SAN:
[root@hypervisor7 ~]# ping 10.62.24.40
PING 10.62.24.40 (10.62.24.40) 56(84) bytes of data.
64 bytes from 10.62.24.40: icmp_seq=1 ttl=64 time=3.11...
Hello I canno connect to the SAN, no ACL is setup, I have other 4 hypervisors connected to the SAN without problems:
[root@hypervisor7 ~]# telnet 10.62.24.40 3260
Trying 10.62.24.40...
telnet:...
Hello, I've just updated our SAN with the last build where irqbalance work properly. No changes had been done to config and I see a performance down in all our dd tests over iscsi. Looking at logs I...
Hello again. I really not understand what is going on. I have very unconsistent results here. With default iscsi values are worst than ever.
Also I have non sense hdparm results on tests.log:
...
Thanks Todd!
Regards
Hello, I've tried to tune iscsi. I've matched the suggested tagets config on this forums with initiators but I had better performance with default config.
Sadly I did not copy it before start...
Hello, how can this be done without tagged interfaces in DSSv6 over a trunked port?
Regards
Mikep