I have 2x 2tb units 0 and 1 showing on my share volume stats but I can only access unit 0. Is there any way to get both visible for storage?
Type: Posts; User: Robbie
I have 2x 2tb units 0 and 1 showing on my share volume stats but I can only access unit 0. Is there any way to get both visible for storage?
Thank you. I'm still a little confused as to the 4.53 available space, and how exactly i format 2 arrays.
Will I need to to start again again from the setup panel to create one more array or can I...
So I might need to enable Auto Carving and or create more than on array, then join them together, or will NAS 2.0 still only see 2 tbs?
How would I create more than one array?
The only other detail I can think of is that the stripe size was set to 64 kb, but I'm not sure if this would have made any difference.
The raid controller is:
3ware 3DM 2 version 2.03.00.025
Below are the details shown from the 3dm ware page. I hope this helps.
Controller Details (Controller ID 2)
Model 9500S-8
Serial # F19402A4470481
Firmware FE9X 2.06.00.009
Driver...
In the html open e Disk manager it reads:
"-- unit 0 --l-- unit size 2190.43 --l-- in use--"
in the html 3DM WARE 2/ unit info/ Controller id 2/ readout it shows:
" --l--unit 0 --l-- RAID...
Re: Auto Carving enabled
No this is not enabled.
In order to keep up with the endless data created while animating I purchased some new drives for our NAS box. It used to run 5x 400 gig drives striped on raid 5. This has worked well for nearly 5...