Visit Open-E website

Search:

Type: Posts; User: jollymon02

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    4,035

    I have 2003 machines connected on the windows...

    I have 2003 machines connected on the windows side, and ESXi 4.1 on the Vsphere side of the house. Same for these?
  2. Replies
    3
    Views
    4,035

    DSS6 iSCSI reset

    Need some input on the function of the iSCSI reset. I have LUNs/Targets created and attached to both Windows and VMware servers. I understand this will disconnect the hosts, but what do I need to...
  3. Replies
    1
    Views
    3,078

    Individual iSCSI Target restart

    I have a volume that was incorrectly configured for iSCSI access, and no deny was in place, so all the machines can see it. I need to restrict it to only 2 ESXi machines. I have those IPs in the...
  4. Replies
    11
    Views
    12,448

    VMFS-3 will be riding on top of this, so I'm good...

    VMFS-3 will be riding on top of this, so I'm good with that. I have created the volume with File I/O, and have got the hosts connected to it. The problem was that I had the old (failed) system...
  5. Replies
    11
    Views
    12,448

    Yes, 2 initiators per host, and 2 hosts.

    Yes, 2 initiators per host, and 2 hosts.
  6. Replies
    11
    Views
    12,448

    HA is not enabled on these two hosts.

    HA is not enabled on these two hosts.
  7. Replies
    11
    Views
    12,448

    Yes, the volume was added to the target during...

    Yes, the volume was added to the target during the target creation. Should I perform the Maintenance/Connection reset as advised? If I do this, will it reset all iSCSI connections? I have a...
  8. Replies
    1
    Views
    3,322

    Network Configuration

    I have two bonded interfaces, each with two physical NICs. The management is on 192.168.10.x and storage on 192.168.11.x. The 192.168.10.x network has the gateway defined correctly and has access...
  9. Replies
    11
    Views
    12,448

    And how would I go about doing that? I don't see...

    And how would I go about doing that? I don't see an option for that. I think during the target creation, I added the LUN to it.
  10. Replies
    11
    Views
    12,448

    Need assistance presenting Volume to host

    All,

    I'm new to VSS6, but not to VMware. I have created a volume and a target for that volume. I have limited the target to the IP addresses (2 per host) coming from my hosts, however, the hosts...
Results 1 to 10 of 12