Search:

Am I right in assuming that this update includes the most needed function for DSS?

So after this update i can add some harddisks, configure my failover task for this drives, and add it to the...

Sorry but the FTP only shows the b4083

Hi there

We want to replicate a volume of 10TB

Ive seen that there was a 4TB limit cause of an old DRDB version.

Is there still a limit?

Thanks

We have several 10GBe NICs from Chelsio: S320E-LP-CR.
They are all recognized by DSS V6.
We connected two machines direct with a SFP+ cable.
At the interface config it shows that there is no cable...

Hi

Is it possible to hav more than on virtual IP on one NIC?
If this isn´t possible, can we create multiple virtual NICs on one pysical NIC?

Thanks

Hello

Has anyone tried the HP NC522SFP 10 GBE Nic in DSS V6?
It has s NETXEN NX3031 chipset, so will this work?

Thanks

We have reinstalled and reconfigured the primary server and it seems that the errors are gone now.

We are running 6.0up04.8101.3530 64bit
Are there any updates i can donwload and install?

Support says it is the RAM.
We´ve done several memtests, no errors found.
We´ve change the RAM with a new one, still got the error messages.

Looks very similar to our Problem
How do you resolved this problem?

Opened a ticket.
Could you tell me what the error was in your case?

Haven´t sent the logs to the support yet.
A memory test did not show any errors.
And yes, it´s only at the primary machine.

Have 4 GB in each machine.
I change the memory and try it again.

Here are some other error messages we get:


2009/09/08 11:52:08 kernel:CPU 2

2009/09/08 11:52:08 kernel:Pid: 22750, comm: apache2ctl Tainted: G D 2.6.27.10-oe64-00000-g9b2116f #12
...

Hi

We habe to DSS v6 Machines running with iSCSI Failover

Every few days we get some error messages:


2009/09/08 03:23:01 kernel:CPU 1

2009/09/08 03:23:01 kernel:Pid: 1175, comm:...

Could somebody tell how to run hdparm to test hd speed?
How could i get access to the console?

thx

I´ve tried every bonding mode for testing purpose, but i never got more speed than 1 GBit/s.
I´ve two replication tasks, both set to a bandwith of 500 to not limit them.
When i only start one rep...

There are lots of data.
There are 2 TB of data which have to be replicated.

OK, ive checked it again, and it also doesn´t work.
It only uses 1 NIC (or on Gigabit/s) of the replication connection.
What i´m doing wrong?
Is it even possible to run a volume replication over...

Now ive done it with a HP Procurve with LCAP on.
It uses all NICs connected to the LACP configured ports.
Direct NIC-to-NIC doesn´t work for me.

Hi

I want to bond 2 or more NICs together and use them only for volume replication.
So i want a higher performance for replication.
I´ve tried several bond modes, but when i start the...