Same subnet is not possible?

[Andy.Yang]

I think you may trunk these 6 interface as one interrface(if these 6 NIC are based on same model chipset).
The "Balance-tlb" function does not require any special switch.
The "Balance-rr" function required Layer-2 switch.
The "802.3ad" function required switch which support 802.3ad.

[To-L]

you can use Same subnet.
But you will receive an error message (just ignore it)

[silicon]

Can we please confirm this? Whenever i have done the initial setup of DSS via the console, if I accidentally have a duplicate subnet, I can never reach the GUI. Always fixed by spotting my mistake & moving one of the Lan ports off to another (temp) subnet.

Is it possible that duplicate subnets affect the GUI but not NAS or iSCSI traffic?