Where enable the option "Label with Barcodes" ?

[stephan123]

Hello,

my tapes have barcodes. I want to label my tapes with their barcode. In help there is written to enable the "Label with Barcodes" ? But where ? I see only the "Label prefix"-Textbox.

-------------------------
Available options:

* Label prefix: Enter a name for the tape. When labeling several tapes at once, the prefix for the second and further tapes will have a number appended, e.g., prefix, prefix1, prefix2, prefix3 etc.
* With erase: When enabled, each tape will be cleared prior to being labeled.
* Limit tape size: Here, you can limit the size of the tape after it has been labeled. When left empty, the tapes will not have any imposed capacity limits.
* Label with barcodes: When enabled, the prefixes for the labeled tapes will be the same as their barcodes. The Label prefix box will be greyed out when this option is on.

Thanks,

Stephan

[To-L]

Please try updating to the latest version.

If that does not fix the problem, send logs to support@open-e.com

[HangaS]

Which version has this feature?

I'm waiting for this feature for quite so long... I'm using a rather new build (3234) and I can't find that option.

Other thing I would like to see it the backup client to be able to find the tape by its label/barcode no matter on what slot is the tape in.

[Sh-J]

Dear HangS,

Did you test it with 5.0_47_build_3216? It seems older than yours, but it was tested with this release and its working.

Regards,
SJ

[stephan123]

Where can i enable the option "Label with Barcodes" or is it automatically detected and shown when open-e recognizes the tape drive to have a barcode-reader ?

I am using the following Version:

Model: Data Storage Server
Version: 5.0.DB47000000.3216
Release date: 2008-08-28
Licensed Storage Capacity: 16 TB

This should be the one where it should be tested with ?

I am using a Quantum Super Loader 3 and the barcodes are displayed in Open-e in the "Label new Tapes"-Section.

I will send you logs and hope to get an answer ...

[HangaS]

Dear HangS,

Did you test it with 5.0_47_build_3216? It seems older than yours, but it was tested with this release and its working.

Regards,
SJ

Then I guess it is because I'm using "In_Engineering_Phase" firmwares. I started using this versions as it was suggested by support in order to fix an issue I had. Since then I'm using this branch as I though It should be more feature rich


This is my current version:

Model: Data Storage Server
Version: 5.0.DB48000000.3234
Release date: 2008-09-26
Licensed Storage Capacity: 8 TB

Quantum SuperLoader 3 and the barcodes are recognized in the label new tapes list. I just can't autolabel tapes based on that.

I'll try the latest "In_Engineering_Phase" and Stable versions during this weekend

[HangaS]

I just upgraded to

Model: Data Storage Server
Version: 5.0.DB48000000.3251
Release date: 2008-10-20

And still can't find that option