Hello

I have DSS working with a point-to-point setup.

QLogic QLE2460 in the client and the same card in DSS server.

I want to get a dual port QLogic QLE2462 card and do 2 x clients point-to-point.

My question is how do I specify which FC target to connect to from each client?
I'm using Linux on the client, has anyone set this up?

Let me explain. I have 2 FC targets on DSS:
lvstorage06 - 250GB
lvstorage07 - 300GB

When I boot my client, it automatically connects to both of the targets:

scsi 8:0:0:0: Direct-Access SCST_FIO G9m9E2YRGmb9Vz3d 096 PQ: 0 ANSI: 4
sd 8:0:0:0: [sdb] 65488640 4096-byte hardware sectors (268241 MB)
sd 8:0:0:0: [sdb] Write Protect is off
sd 8:0:0:0: [sdb] Mode Sense: 6b 00 10 08
sd 8:0:0:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FUA
sd 8:0:0:0: [sdb] 65488640 4096-byte hardware sectors (268241 MB)
sd 8:0:0:0: [sdb] Write Protect is off
sd 8:0:0:0: [sdb] Mode Sense: 6b 00 10 08
sd 8:0:0:0: [sdb] Write cache: enabled, read cache: enabled, supports DPO and FUA

sd 8:0:0:1: [sdc] 78587392 4096-byte hardware sectors (321894 MB)
sd 8:0:0:1: [sdc] Write Protect is off
sd 8:0:0:1: [sdc] Mode Sense: 6b 00 10 08
sd 8:0:0:1: [sdc] Write cache: enabled, read cache: enabled, supports DPO and FUA
sd 8:0:0:1: [sdc] 78587392 4096-byte hardware sectors (321894 MB)
sd 8:0:0:1: [sdc] Write Protect is off
sd 8:0:0:1: [sdc] Mode Sense: 6b 00 10 08
sd 8:0:0:1: [sdc] Write cache: enabled, read cache: enabled, supports DPO and FUA


I've looked at the SANsurfer CLI manual but I can't find any thing relevant. There is a chapter on Target Persistent Bindings, but this menu does not exist in my SANsurfer tool.

How do I stop the disks automatically connecting?

Another problem I have is that the SANsurfer tool is now missing in DSS. How do I restore it?

Thanks