Error(s) on san2 from Replication

[zeki893]

The san2 is connected to foundry netiron mlx and san1 is on the same router. they are both on the same vlan
san1 172.16.0.2
san2 172.16.0.64
vip 172.16.0.32

[To-M]

So if you have 4 tasks via your iSCSI volume replication and the error message is indicating that LV0002 has an Unknown state but shows it is consistent then the other 3 are ok. I would check the Destination server LV0002 to make sure it is properly set for scsi ID, LUN, Target name and make sure it is enabled as well as the Volume Replication manager to make sure that it is set to destination. Also on the Source. All the other 3 iSCSI Volumes are not showing errors so it must be something with the LV0002.

[zeki893]

i actually got it to work before with the demo and i had all the stuff you mentioned setup on both servers.
I don't know why its not working now, but I stopped the replication and failover since its in production now.

[zeki893]

also want to mention i didn't have the error just on lv002 it was on all of them, i just didn't post it since they were all similar

[To-M]

So you have verified that the Targets Names are the same and the LUNS and the SCSI ID's.

Also the Bond is in good working standing - no errors from the dmesg logs like "Link is down".

I was thinking of failing over to the secondary then once this is done sync from the secondary then switch back to the primary. It might clear this up.