Error(s) on san2 from Replication
2008/12/22 18:16:05 Replication:Volume Replication: Device lv0002: Connection (from Connected to WFConnection). Mode local/remote (from Secondary/Primary to Secondary/Unknown). DataStatus local/remote (from Consistent/Consistent to Consistent/DUnknown).
2008/12/22 18:16:15 Replication:Volume Replication: Device lv0002: Connection (from WFConnection to Connected). Mode local/remote (from Secondary/Unknown to Secondary/Primary). DataStatus local/remote (from Consistent/DUnknown to Consistent/Consistent).
I keep receiving these errors. Did I set something up incorrectly?
When I check in tasks the volume replication is consistent/consistent
Does both systems state in the Failover section that it is OK or Degraded?
All the best,
Todd Maxwell
hm.. this is strange.. when i first started the service everything was ok
Service running degraded
Node status primary/active
Ping node ok
Communication via:
bond0 failed
eth1 failed
I have 4 failover tasks and they all state connected and consistent
so is there anything I can do?
Is the Bond 0 dedicated to the Volume Replication setup and the Eth 0 dedicated to the Virtual IP Address. Since the Ping node is OK and the consistent state is ok it almost sounds like some hardware issue. Though hard to tell when the status is showing ok.
With NIC's showing status failed could be an intermittent switch issue, what is the network setup like?
All the best,
Todd Maxwell
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules