Member
DSS V6 Lite - No units found
I just installed DSS V6 Lite (dss6.0up04.oe_i.zip). While installing i entered fdisk und deleted everything to start from clean. Later in "CONFIGURATIONvolume managerVol. groups" i scan for units and get only "No units found". What now?
It is the same problem like in the beta.... http://forum.open-e.com/showthread.php?p=6284#post6284
"Security is like an onion - the more you dig in the more you want to cry"
Administrator
Member
I use the raidcontroller i linked in the start posting, an Intel Corporation SCRU32 with RAID5. Do you need more info?
"Security is like an onion - the more you dig in the more you want to cry"
Administrator
Can you try with the DSS V6 Trial version. When you installed DSS Lite did you install on a USB stick or on a RAID set. When you go into the GUI in Setup > HW RAID does it show anything or in the Status > Hardware > drivers... does it show up there? Try setting the RAID controller for the drives as single drives and do you seen them in the SW RAID function of the GUI.
Member
I installed it on the raid. The Unit manager doesn't find anything, but the raid-controller is listed with RAID/SCSI controllers: Intel Corporation SCRU32.
In the trial Version dss6.0up04.oe_i.iso which boots up with dss6up1 b3530, i see the raid controller in the unit manager.
Why should i switch to software raid if i had an 128MB HW-Raid-Controller?
"Security is like an onion - the more you dig in the more you want to cry"
Administrator
With DSS V6 Lite we dont have RAID controller support it is noted in the comparison list and is the reason I was asking if you could set the drives as single drives to see them.
http://www.open-e.com/products/open-...te/comparison/
If this is DSS V6 Lite that we are talking about this should be posted in the DSS Lite section.
Posting Permissions
Reply With Quote