nightmare99 (what a username!), we supply the MC2, & the Storview application, tho available in Linux flavour, is not installed "inside" DSS. Instead, Intel/Xyratex supply storage software developers like Open-E with hardware monitoring code/modules that they can use to integrate with their software.

DSS's interface is the Status > Hardware > Hardware monitoring page/section, certainly not providing the full suite of sensors etc. you see in Storview, but not too bad. What makes it sufficient as I see it, is the SES/SES2 monitoring capabilies that come with the applicable SAS RAID agent built in to DSS (eg. LSI MegaRaid module for us), that monitors SAS enclosures (via SES), & can notify if enclosure (local for the MC2, or/and externally connected SAS JOBODs etc) sensors (fan speed, PSU etc.) go critical etc. Just FYI, we see better SAS/SES info from a Promise J-series SAS JBOD connected to the MC2 than from the MC2 itself!

Re. detailed RAID information, if required, we use RWC to remotely connect to the MC2, but there is also a built-in MegaRAID GUI now, that has much of the RWC console's functionality, plus the full command-line version is available from the DSS console (local or remote, but only if you have enbled it 1st!).

Finally you have the MC2's BMC that can issue smtp/snmp alerts for major hardware-level events.
Oh, and there's some good generic snmp MIBs exported by DSS and I thinik the LSI MegaRaid agent too, though this can get all a bit technical & complicated.
Hope this helps.