Volume manager can not use added space

[Zeger]

The raid controller is an ARC-1680 and the controllers reports complete on the array expansion moreover: the volume manager reports 11000Tb.

[To-M]

Try one more restart of the system then send in the logs if this capacity does not return properly.

[pvinne]

Hello,
we have the same issue with a 3Ware 9650-SE 12-port Controller. We had 6x1TB in a RAID 6, added 3x1TB, waited for the controller to finish the resize and then did the pv resize. Now i see 6519GB in the volume manager, but cannot assign the space to the existing logical drives nor can i create new drives - the slider is just fixed. Same after 2 reboots.
Is there any solution to this?

[To-M]

Send in a request to support@open-e.com with logs and and ask for remote support - i want them to look into this.

[silicon]

Any update on this one, as we have just seen the same thing on a LSI MegaRaid controller.

It took a couple of reboots (after the pv resize) just to get the new size to report correctly in Unit size, but as above posts, free space is still incorrect. I have submitted logs to support anyway (Ticket#1010974), this post is just say it's not a 3ware etc. Raid controller-specifc issue. Cheers.

[HangaS]

I have the very same issue here.
A disk was added to the array and with some console command I was told to run, the total volume space reflects the new size. However the sum of the used and free space still add up only to the previous volume size.

[To-M]

Did you send in the log file to support and what RAID controller are you using.