iSCSI performance Vs Samba

[sgiusto]

Nice try...
The problem is with iSCSI only. with samba performance is OK.
In any case here are the values you asked for:
*-----------------------------------------------------------------------------*
hdparm -t /dev/cciss/c0d1
*-----------------------------------------------------------------------------*


/dev/cciss/c0d1:
Timing buffered disk reads: 148 MB in 3.01 seconds = 49.14 MB/sec

ethtool eth0
*-----------------------------------------------------------------------------*

Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 1
Transceiver: internal
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Current message level: 0x000000ff (255)
Link detected: yes

[To-M]

Just from my DSS Lite test with my 3Ware I get higher when enabling the cache.

hdparm -t /dev/sda
*-----------------------------------------------------------------------------*
/dev/sda:
Timing buffered disk reads: 354 MB in 3.00 seconds = 117.99 MB/sec

Also are these ES (Server ) drives. Try direct connecting to the server. You might want to force the speed to 1000 instead f auto neg in the modify driver feature in the Console Tools.

[sgiusto]

Hello,
the machine is quite old and 50mb/sec is fine for my purposes.
the problem is that I have that kind of performance when writing using samba.
When using ISCSI I have 3MB/sec only!
The problem is not in the network or disk array (samba is perfoming fast enough), I think the problem is with some parametrt in the scst configuration.

[To-M]

Did you enable the WB for the LUN. What are the Target settings for the Max burst length and Xmit....

Test with the DSS V6 Trial version - latest build is 3535.

[sgiusto]

WB Enabled.
Tried different settings:
Default
The one I have on another linux box with SCST and that shows far better write performance
the one proposed for vsphere in some other post
Write performance is always 3MB/sec

[To-M]

The other linux box with SCST in fileio what are the performance reads and what is it and was this tested on the same system and can we get the hdparm from there logs with this box.
Is the linux box 6bit mode what are the specs....

I believe this might be isolated as I dont have older systems to test with. Can you test with DSS V6 Trial version?

Also look at the dmesg logs to see if we can see anything that could possibly be going on.

[sgiusto]

The other linux box is my production SAN.
it is newer (E200i controller, SAS 15k disks, 4GB RAM, hdparam is about 130MB/sec) and I cannot use for testing.
It is fileio on an entire partition of a logical RAID5 disk.
I am testing DSS V6 trial (latest build) on an older box to see if its performance is good enough to use in production.
Since write performance with iSCSI is poor, I tested with samba to ensure that my older hardware is ok.