Quote Originally Posted by juergenb52
After a change in the test scenario the read performance seems to fine.

With totalcommander it could test a read performance of 55MByte/sec and a write performance of 57MByte/s in a RAID0 with one disc!!
Hi,

I've also found writes faster than reads, in our case using block mode iSCSI. Not completely got to bottom of it yet. Had a similar issue with OpenFiler, although with DSS the gap seems slightly smaller. This is on a HP DL380G5 with P400 SmartArray 256MB BBWC and 8x SAS disk in RAID6. Get around 60-90MB/sec write and 30-40MB/sec read.

Just wondered if you could elaborate on the scenario issue? Do you mean you tweaked how you were measuring performance and got a faster speed or did you make some changes to DSS config? I'm also not clear on the significance of RAID0 with one(?) disk.

Thanks for any feedback, Andrew