Hi...
Has anyone had positive experience with the Qlogic 8Gb/s HBA's. Eg. QLE2560
QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA (rev 02)
Looking to make my Axus Direct Attached storage available as a FC target.
-Adam
Hi...
Has anyone had positive experience with the Qlogic 8Gb/s HBA's. Eg. QLE2560
QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA (rev 02)
Looking to make my Axus Direct Attached storage available as a FC target.
-Adam
Well I replaced my 8Gb Qlogic HBA with a QLA2460, but the target mode doesn't load.
The card is on thne supported hardware list so I'm guessing it's something else.
2009-10-29 9:52:37 fc module 'isp_scst' is allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/1/1, loading
2009-10-29 9:52:38 fc module 'isp_mod' is allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/1/1, loading
2009-10-29 9:52:38 fc module 'qla2xxx' isn't allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/0/1, not loading
I don't think 8GB is supported yet
This is saying that the intitiator driver 'qla2xxx' isn't allowed to load, this is because you set it to target mode.Originally Posted by adamvh
Regards,
Eddo
Hi guys, any update related QLE2560 support? we have a QLE2560 setup and consider using DSS.
I haven't had problems using the Qlogic 8Gbit QLE 2560 HBA with open-e. It also worked fine after down-grading it to the QL2460. Make sure to check that it is set to target mode... that gets me every time.