Qlogic 8Gb HBA Supported?

[adamvh]

Hi...

Has anyone had positive experience with the Qlogic 8Gb/s HBA's. Eg. QLE2560
QLogic Corp. ISP2532-based 8Gb Fibre Channel to PCI Express HBA (rev 02)

Looking to make my Axus Direct Attached storage available as a FC target.

-Adam

[adamvh]

Well I replaced my 8Gb Qlogic HBA with a QLA2460, but the target mode doesn't load.
The card is on thne supported hardware list so I'm guessing it's something else.


2009-10-29 9:52:37 fc module 'isp_scst' is allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/1/1, loading

2009-10-29 9:52:38 fc module 'isp_mod' is allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/1/1, loading

2009-10-29 9:52:38 fc module 'qla2xxx' isn't allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/0/1, not loading

[eppo78]

I don't think 8GB is supported yet

2009-10-29 9:52:38 fc module 'qla2xxx' isn't allowed to load: INIT/TARGET/INITTARGET=0/1/0, a1/a2/a3=1/0/1, not loading

This is saying that the intitiator driver 'qla2xxx' isn't allowed to load, this is because you set it to target mode.

Regards,

Eddo

[adamvh]

[paulliebregts]

Hi guys, any update related QLE2560 support? we have a QLE2560 setup and consider using DSS.

[Robotbeat]

I haven't had problems using the Qlogic 8Gbit QLE 2560 HBA with open-e. It also worked fine after down-grading it to the QL2460. Make sure to check that it is set to target mode... that gets me every time.