Since upgrading to V6 back in December I have been having problems getting the fail-over service to start, despite going through the setup of volumes, targets, networking etc 2 or 3 times now.
I keep getting a "Configuration of both nodes finished with errors." message each time I try and start the service on the primary.
I am using 6.0up14.8101.4221 32bit with File I/O iSCSI volumes that have been initialised.
The replication tasks are running Ok and consistent but don't know what has changed or what I am doing wrong.
Is there anywhere I can look to see what may be causing this or can anyone offer advice on how to resolve?
Thanks
Andrew