Cannot create new iSCSI volume

[PeterinNewZealand]

Can you try with another browser like Firefox or try to clear the cache on the browser or use another PC to connect to the DSS V6.

Did try Firefox but that complained about "peer certificate invalid signature, error code sec-error-bad-signature"

Can you see the support calls that have been logged and the responses?

[To-M]

Access the console screen then enter CTRL + ALT + T then Boot options then System architecture then select 32bit mode. Save then reboot the system using CTRL + ALT + K, your volumes are ok it is because the DSS V6 defaults to 64bit mode.

[To-M]

I would also do a RAID health check for the Array to make sure that the drives or the Array are ok.

[PeterinNewZealand]

After resetting the USB speed on the system board from USB 2 to USB1.1, we were able to boot from the DOM and are back in business, volume groups, logical volumes and most importantly data are all good. That was a very interesting 12 hours!

While this is excellent news short term, does it mean the DOM is on the way out and should be replaced?

I have suggested to management that we upgrade to DSS - if we do upgrade, does that come with a DOM? Also, where is a good upgrade guide for DSS to be found?

[To-M]

There is a new price for the upgrade link below. You can reuse your existing DOM or other media - also there is upgrade instructions from the readme file and or the Quick start guide from the support page.

http://www.open-e.com/store/#upgrades