Visit Open-E website
Results 1 to 2 of 2

Thread: ssh (remote access) to open-e

  1. #1

    Default ssh (remote access) to open-e

    Hi,

    I'm trying to ssh to my open-e box to see the status of 802.3ad because I dont think it's working properly and there isnt much troubleshooting I can do from the web interface...

    My XenServer 's keep getting errors like this:
    May 28 15:17:47 Unix01 iscsid: Nop-out timedout after 15 seconds on connection 1:0 state (3). Dropping session.
    May 28 15:17:59 Unix01 iscsid: connection1:0 is operational after recovery (2 attempts)


    When I do ssh to open-e, all I see is this... Where is the unix prompt so I can check /proc statuses etc?

    Welcome to Data Storage Software V6 (Press F1 for help)
    -------------------------------------
    Model: Data Storage Software V6
    Version: 6.0up35.8101.4452 64bit
    Release date: 2010-05-07
    S/N: A0014841
    Licensed storage capacity: 8 TB

    Network settings:
    Interface 1: eth0 IP:10.10.20.200/255.255.255.0
    Interface 2: eth1 IP:202.1.1.1/255.255.255.224
    Interface 3: bond0 IP:172.16.31.200/255.255.255.0

    HTTPS settings:
    port: 443
    allow from: all


    Anything I do, CTRL c, F1 or anything, it just doesnt do anything from cli ssh

    any help would be appreciated.
    thanks
    barry

  2. #2
    Join Date
    May 2008
    Location
    Hamburg, Germany
    Posts
    108

    Default

    Barry,

    open-e DSS is an open-source-based closed system - you're not granted direct shell access.

    Regards,

    jmo

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •