Unable to stop snapshot

[To-M]

You can check if Snapshots are used or assigned to the volumes from the Volume manager and there you should see a check mark if assigned to the volumes.
Is the Snapshot large enough to the volume at least 12% of the total volume size?

You will have to restart after update. If the update does not fix the Snapshot still unable to remove then yes use the Extended tools but there will be a restart.

[joe-farka]

Hi Todd,

sorry for the delay, I had a lot of work.
I have rebooted the NAS this morning. It takes me 1 hour because my external LDAP (as declared in the NAS) was down (because it is a VM). And so the NAS was a little bit lost without connection to its LDAP. I had to turn into internal LDAP, reboot it again because NFS was crashed. Once up and NFS working, start my VMs (then the ldap server) and turn into external LDAP again. Perhaps there are some tickets on it (??).

Anyway, after that pain, I was able to turn off my snapshot (without update).

Thank you very much Todd for your help.

joe
ps: I do not know if there is a way to turn this thread to solved.

[To-M]

Hey Joe - Thanks for the update, I checked for any tickets and found none but we could post on our knowledge base for an article.