Emulex FC HBA

[m.casco]

Ok, now i have brought two Emulex FC HBA.
But the OPEN-E DSS V6 is not reconizing it, why?

[m.casco]

OK, will go back to openfiler.

Thanks!!!

And i was using DSS V6 trial!

[To-M]

If you are using the Trial then this will work but then why is this post on the DSS V6 Lite?

If you send in logs we can look at them but this is the wrong area for the Trial as this is the Lite posting.

[m.casco]

Thanks for the quick reply!

I have uninstalled the DSS V6 Trial now, but the message that was on screen was:

- Configuration -> FC Target Manager:

Warning: No Fibre Channel Host Bus Adapter found. All Groups and HBAs settings will be saved but will have no functionality until you plug in appropriate HBA card.

- Status -> Hardware:

Fibre Channel controllers
Emulex Corporation LP1150 Fibre Channel Host Adapter

The funny thing is that the software says EMULEX in "Setup > Fibre channel"

AND!

In the software comparsion chart says Don´t suppor MULTIPLE FC not for one.

Thanks!!

[To-M]

Keep the trial on but then send in the logs so we can take a look at them. I will have to move the other postings.

[m.casco]

OK.

Fresh install, here are the logs:
http://descargas.fiesa.com.ar/descar...rios/TRL00022_[5087]_logs_2011-02-15_21_31.tar.gz

Please confirm, can i use at least one single FC card on DSS V6 Lite?

Thanks!!!