Emulex FC HBA

[To-M]

If you are using the Trial then this will work but then why is this post on the DSS V6 Lite?

If you send in logs we can look at them but this is the wrong area for the Trial as this is the Lite posting.

[m.casco]

Thanks for the quick reply!

I have uninstalled the DSS V6 Trial now, but the message that was on screen was:

- Configuration -> FC Target Manager:

Warning: No Fibre Channel Host Bus Adapter found. All Groups and HBAs settings will be saved but will have no functionality until you plug in appropriate HBA card.

- Status -> Hardware:

Fibre Channel controllers
Emulex Corporation LP1150 Fibre Channel Host Adapter

The funny thing is that the software says EMULEX in "Setup > Fibre channel"

AND!

In the software comparsion chart says Don´t suppor MULTIPLE FC not for one.

Thanks!!

[To-M]

Keep the trial on but then send in the logs so we can take a look at them. I will have to move the other postings.

[m.casco]

OK.

Fresh install, here are the logs:
http://descargas.fiesa.com.ar/descar...rios/TRL00022_[5087]_logs_2011-02-15_21_31.tar.gz

Please confirm, can i use at least one single FC card on DSS V6 Lite?

Thanks!!!

[To-M]

We dont provide FC support for the Lite product only the Full Version.

In the logs I do see the Emulex and we are loading it so it can be used as an initiator but not as a Target.

Emulex LightPulse Fibre Channel SCSI driver 8.2.7
Copyright(c) 2004-2008 Emulex. All rights reserved.
lpfc 0000:01:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
lpfc 0000:01:00.0: setting latency timer to 64
scsi5 : on PCI bus 01 device 00 irq 16

[m.casco]

OK To-M, thanks for your support but at present, DSS V6 is not an option to me.

[m.casco]

OK, now i have one more chance to use OPEN-E DSS V6.
The QLogic QLE2462, is compatible with the DSS V6 in target mode?

Thanks!!