Greetings!

I am testing the backup capabilities of DSS (using a VMware ESXi 4.1u1 VM) by following the direction from "Setting up data redundancy on DSS V6 within a system". I have 2 virtual disks, one for the data, one for the backup (no HW/SW RAID, just volumes). When I get to the section on labeling tapes, I select the VirtualTapesGroup, enter a name, set a limit (have tried with and without a limit) and click apply. It thinks for a few minutes, then comes back. No error or anything, just refreshes the information and lists no tapes... as if I hadn't done anything.

I followed the instruction in this KB article to refresh the backup DB, but that didn't help.

Any ideas?