Hello,
weŽre having trouble integrating our both Open-E DSS V6 machines into out FalconStor Infrastructure. Right now we have:
2 FalconStor IPStor Nodes
2 HP EVA3000 (Already productive)
2 SuperMicro Machines with Open-E DSS V6
All hooked up to an FC SAN.
We successfully integrated one Open-E machine via FibreChannel by now, so the FalconStor Nodes can the see the LUN we created (4 TB). But when weŽre trying to use the Open-E FC Volume for the FalconStor Storage Pool, we get an Error Message stating that the IPStor Parition canŽt be created.
I passed the issue to the technical support from our FalconStor Reseller, including the Logs from the FalconStor nodes. The support told me that it looks like the Open-E Software doesnŽt Support Cluster Shared Volumes (or Host Multi access), because the 2 FalconStor Nodes are unable to access the Volume on the Open-E simultaneously (which is neccessary when doing mirroring / Failover).
Is this a known limitation of Open-E or kust not supported (yet)
Hi,
Under "Configuration->FC Target manager->WWN Aliases" we added the Initiator WWNs from both FalconStore Nodes (4 WWNs) and assigned them to the FC Group. We also set the QLOGIC Adapter under "Setup->Fibre Channel" into target Mode.
So just to confirm that you are able to use the FC Target from the DSS V6 with only 1 FalconStor Nodes? I just want to make sure that the 4TB can be seen and used without the Host Multi access from the pool. So if you have 1 WWN entered (not all 4) can the FalconStor use this LUN?
We have not tested with this setup so this is where the investigation begins and typically a when accessing with multiple host you would need some SAN filesystem or a VMware HA setup or MS Cluster. But lets define first if you are able to successfully use the LUN with 1 Node.
Ok, I tried that, but the error is still the same when trying to assign the LUN as an Virtual Device in the FalconStor Console: (Cannot create IPStor partition while attempting to change category") and ("Failed to change physical device (SCSI_FIO.....) category".
Well, IŽm not sure but I (think) I found the Problem: I created a new LUN with 16 GB and changed the default Sector Size from 4096 to 512 Kb, and after that I was able to assign the Volume, even with all Initiator WWNs from the FalconStor. IŽll keep testing.
I was refering to the online help when creating FC Target, so I selected 4096
Blocksize
This option is available when creating a Fibre Channel volume (FC). Blocksize indicates the nominal size, expressed in bytes, of a block of data. Possible values:
Blocksize has an influence on performance and space management. The greater value the better performance, but data might take up more space. This option is unavailable when modifying an FC volume and for FC snapshots.