Visit Open-E website
Results 1 to 3 of 3

Thread: SW RAID1 Rebuild

  1. #1

    Default SW RAID1 Rebuild

    Hi,

    iam just starting with testing Freenas Dss V6 lite . I have it installed on an QNAP NAS and sofar it works good.
    I have installed two 2TB Disks as SW RAID1. Now i have taken out one drive for about 2 min and restored it than again.
    I got mails notification about that probelm. So far so good.
    But now i just dont find an way how to activate an rebuild of the raid.
    I have searched in forum, but just didnt find anything that realy made me understand what to do.
    Can anybody give me an tip what steps i have to take ?

    Thanks a lot

  2. #2

    Default

    It should be in the SW RAID feature informing of the rebuild or in a state of DEGRADED mode or it has already completed the rebuild.
    All the best,

    Todd Maxwell


    Follow the red "E"
    Facebook | Twitter | YouTube

  3. #3

    Default SW RAID1 Rebuild

    Hi,

    i was an bit too fast with my post.
    i think i have just found the way:
    - remove with extended console tools content of disk that i took out
    - reboot
    - then mark it in web gui as spare for md0 raid
    - rebuild starts

    But thanks anyway for fast reaction :-)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •