SNMP Sensors Statistics mismatch the Statistics in switch
Hi Folks,
I use Open-E's function "STATUS ->statistics->network" today it show me only
about 100Mb/s. But in my 10GbE switch it show me as following(1.62 Gbps):
===============================================
7124S>show interfaces port-Channel 200
Port-Channel200 is up, line protocol is up (connected)
Hardware is Port-Channel, address is 001c.7308.db0d
MTU 9212 bytes, BW 20000000 Kbit
Full-duplex, 20Gb/s
Active members in this channel: 2
... Ethernet23 , Full-duplex, 10Gb/s
... Ethernet24 , Full-duplex, 10Gb/s
Last clearing of "show interface" counters never
30 seconds input rate 19.5 Mbps (0.1% with framing), 12271 packets/sec
30 seconds output rate 1.62 Gbps (8.2% with framing), 138009 packets/sec
448547262 packets input, 91257547530 bytes
Received 7981 broadcasts, 28906 multicast
0 input errors
4771875937 packets output, 6987077858961 bytes
Sent 40 broadcasts, 60720 multicast
0 output errors
===============================================
Could anyone tell why the statistics are mismatch?
PS.
1.Open-E's screen capture :
2.The bond0 interface was bonding with two Intel Corporation Ethernet Server Adapter X520-2 two 10GbE SFP+ port. Switch is Arista 7124 10G switch with 802.3ad Protocol.
I have these cards in our labs, can you tell me what you are seeing when you go into the Console and enter CTRL ALT N then select the 10GbE NIC then go to Info and does it say SPEED 10000