I did the test :
*-----------------------------------------------------------------------------*
hdparm -t /dev/sda
*-----------------------------------------------------------------------------*


/dev/sda:
Timing buffered disk reads: 774 MB in 3.00 seconds = 257.96 MB/sec

(Same results on sdb, sdbc, sdd)

*-----------------------------------------------------------------------------*
hdparm -t /dev/sde
*-----------------------------------------------------------------------------*


/dev/sde:
Timing buffered disk reads: 400 MB in 3.00 seconds = 133.25 MB/sec

This is the last SSD, it is a bit slow !

*-----------------------------------------------------------------------------*
hdparm -t /dev/sdf
*-----------------------------------------------------------------------------*


/dev/sdf:
Timing buffered disk reads: 274 MB in 3.02 seconds = 90.81 MB/sec

This is the 2x 2.5" RAID1 HDD used for DSS installation

*-----------------------------------------------------------------------------*
hdparm -t /dev/md0
*-----------------------------------------------------------------------------*


/dev/md0:
Timing buffered disk reads: 1884 MB in 3.00 seconds = 627.64 MB/sec

It's a bit slow for a Raid5 of 5 SSD, maybe the problem is caused by sde...

*-----------------------------------------------------------------------------*
ethtool bond0
*-----------------------------------------------------------------------------*

Settings for bond0:
No data available

It that normal?

All eth0,eth1,eth2 are set to 1000Mbit/s and no errors occured.


Version of DSS : 6.0up75.8401.5377 64bit