Failover configuration synchronization on both nodes take long time

[Gr-R]

degraded is normal , while sync is reached.
can you give some screen shots from both nodes ?
If you can PM me logs, or link me to them, that can help too.

If I have time tomorrow, perhaps I can take a look at your systems via team viewer or something similar.

[cloudtech]

I will send you the screenshot and logs when it's ready. Thanks.

[cloudtech]

Hi Gr-R,

I have re-installed the SAN servers, now the failover is working fine. Thank you.

[Gr-R]

I suspect there was an issue in writing the initial config files for the failover service.
I have seen that happen once or twice..... sometimes its as simple as resetting the files. This can be done by de-selecting the failover services, and clicking apply, then re-selecting them, and clicking apply. Then re-enable failover.