open-e failover for onapp cloud

[cloudtech]

Sorry to bother you again. I have the following setup, but I am not able to ping the virtual IP from both SAN servers. In the video, I see they can ping each other. Should I setup 192.168.100.254 as gateway? Thanks.

Primary SAN

eth0 - management network - 192.168.1.207
Gateway - 192.168.1.254
eth1 - SAN storage network - 192.168.2.207
eth2 - Replication network - 192.168.3.207

Secondary SAN

eth0 - management network - 192.168.1.208
Gateway - 192.168.1.254
eth1 - SAN storage network - 192.168.2.208
eth2 - Replication network - 192.168.3.208

Virtual IP is on eth1 for both SANs
IP address: 192.168.100.100
Netmask: 255.255.255.0
Broadcast: 192.168.100.255

[Gr-R]

It does seem like your gateway is not handling the virtual IP, and its subnet.
You should check this.
Or, if the failover service is not yet started the Virtual IPs are not up and available yet.

[cloudtech]

The failover status shows the Communication via Storage link is OK. I am not sure how the gateway is handling the virtual IP. Do I need to do any special setup in the Switch(both SAN are connecting to the same switch)? Trunk the 192.168.100.* network?

[cloudtech]

Please ignore my last reply. I may found the problem.

[Gr-R]

well...... what was it?

[cloudtech]

It's my network setup problem. My hypervisor server is using 192.168.2.4, but my SAN virtual IP was 192.168.100.100. I switched the virtual IP with the Storage access IP and now the failover is working.