It does seem like your gateway is not handling the virtual IP, and its subnet.
You should check this.
Or, if the failover service is not yet started the Virtual IPs are not up and available yet.
Genius
It does seem like your gateway is not handling the virtual IP, and its subnet.
You should check this.
Or, if the failover service is not yet started the Virtual IPs are not up and available yet.
Member
The failover status shows the Communication via Storage link is OK. I am not sure how the gateway is handling the virtual IP. Do I need to do any special setup in the Switch(both SAN are connecting to the same switch)? Trunk the 192.168.100.* network?
Member
Please ignore my last reply. I may found the problem.
Genius
well...... what was it?
Member
It's my network setup problem. My hypervisor server is using 192.168.2.4, but my SAN virtual IP was 192.168.100.100. I switched the virtual IP with the Storage access IP and now the failover is working.
Posting Permissions
Reply With Quote