Error in rsync protocol data

[Gr-R]

instructions are in the release notes.

but its very simple, upload the new image in the wegui, accept the update, and reboot.

[dljordaneku]

It took around 30 hours but it finally finished. I did upgrade the destination box and now I have another issue but I created a new thread for it.

dj

[Al-S]

It's good to hear that all your issue now works fine, and for you other post that the system hang at 90%, just give it sometime, and as you told us it works fine after you wait for sometime on it.

The long time that you face could be related to your RAID system, so if you rebuild the array sure it will take very long time (sometimes over 24 hours, as that depend on the storage capacity, system speed, RAID controller, RAID type that you are using as RAID 1,0,5,6 etc..).

And if the long time goes for the update process, then that could be related to your internet speed, as if you have more than one system and you want to update them with a slow internet speed connection, we recommend that you install the ISO image of DSSv6 then check it with the .MD5 sum file to be sure that it downloaded fine, then use it to update your systems.

Also if updating your system take long time, even if you are using the ISO (already downloaded) image, then it is better to check your DOM/USB or your File System.