Replication DiskLess

[To-M]

For MTU, i can't change it. When Bond is up, with the console management i can only change the MTU for Bond not the MTU for each attached NIC :

So you created the Bond without setting both of the NICs to Jumbo frame value - then you will have to schedule some down time then to break the bond and set the other NIC to the proper Jumbo frame and re-create the bond.

[nsc]

Thanks for the info about MTU on Bond.

[nsc]

After the restart of replication task, the lv0003 goes down and nothing working anymore.
I have to hard reset my two ESX Host after a proper restart for OpenE.

But the data stored n VMDK from LV003 are corrupted

I think the hard reset was too hard...

[Al-S]

Did you checked your RAID Controller health, also your RAID Array (storage disks) health?

[marajenda]

hey guys i am here and i want to know much more about DSS.

(Advertising link deleted by Open-E team).

[Al-S]

You can get the manual from our website at:
http://www.open-e.com/service-and-su...loads/manuals/

Or contact us as mentioned in the "contact us" menu in our website.

[tle]

Hi,
we have exactly the same problem (but we are not bonding and our mtu is set properly). After some network errors and dropped packages we have the state consistent/diskless on three LV as can be seen here:
http://imageshack.us/photo/my-images/42/diskless.png/
There were no errors from the Raid-controller.
How can we come back to a consistent/consistent state?
I have also opened a ticket for this: 1031171