cannot connect to SAN

[mikep]

Hello I canno connect to the SAN, no ACL is setup, I have other 4 hypervisors connected to the SAN without problems:

[root@hypervisor7 ~]# telnet 10.62.24.40 3260
Trying 10.62.24.40...
telnet: connect to address 10.62.24.40: Connection refused
telnet: Unable to connect to remote host: Connection refused
[root@hypervisor7 ~]# iscsiadm -m discovery -t sendtargets -p 10.62.24.40
iscsiadm: cannot make connection to 10.62.24.40: Connection refused
iscsiadm: cannot make connection to 10.62.24.40: Connection refused
iscsiadm: cannot make connection to 10.62.24.40: Connection refused
iscsiadm: cannot make connection to 10.62.24.40: Connection refused
iscsiadm: cannot make connection to 10.62.24.40: Connection refused
iscsiadm: cannot make connection to 10.62.24.40: Connection refused
iscsiadm: connection login retries (reopen_max) 5 exceeded
iscsiadm: Could not perform SendTargets discovery: encountered connection failure

We have one license but not in this SAN, we are doing some tests. Is trial license limited in someway that explains this?

Regards

[Gr-R]

the trial has no limits on connections.

check your routing to the storage IP.

[mikep]

Sorry, I forgot to mention I can ping the SAN:

[root@hypervisor7 ~]# ping 10.62.24.40
PING 10.62.24.40 (10.62.24.40) 56(84) bytes of data.
64 bytes from 10.62.24.40: icmp_seq=1 ttl=64 time=3.11 ms
64 bytes from 10.62.24.40: icmp_seq=2 ttl=64 time=0.085 ms
64 bytes from 10.62.24.40: icmp_seq=3 ttl=64 time=0.062 ms

Regards

[mikep]

I also checked SAN logs and the only thing I can find about ip I try to connect from is I can see ip in arp -nv output. No other log show anything about this ip. Even tried to add to de ACL, without success.

Regards

[Gr-R]

is this a virtual IP assignment? If so, make sure failover service is running.

Any bonds, vlans ?

[mikep]

Hello, no bonds, vlan yes, but access mode, same config than the other Hypervisors and switch ports that are currently running ok.

Regards