Hi there

I have just installed 6.0up45.8101.4622 64bit from cd onto an older Dell 1850 with Perc controller dated 2004 (perc 4?)
Before installation I created 2GB and 130GB LVM partitions with volume groups on them. There is no facility to create volume groups in the Perc Controller, one can only create arrays. So I had to go through the motions of setting up Centos to create the volume groups. (Wouldn't it be possible to add an LVM managed to DSS? It would save a lot of hassle).

During installation I was prompted to install dss on either the 2GB or 130GB partitions. After installation however (when booting from drive), the system says "no units found". ie the 130GB LVM group is missing

Is this because I have a trial version of the software? I don't think I have the "Lite" version.

Best
Dude