I had a crashed Open-E failover cluster, the systems wouldn't boot beyond the 90% anymore unless I disconnected all the network cables OR booted in 32-bit mode (but then the volumes were not accesible because these were 64bit).

Finally I had the systems up and running again. I removed all the failover configuration (because there was some recovery-speed involved) so I connected the Xenserver (iscsi) directly to 1 DSSv6.

Now I want to remake the failover configuration but every time I want to start the failover on the primary for the first time, it says:
"Configuration of both nodes finished with errors"

Which means I can't get it to work. I checked all the settings, aux. IPs, Virtual IPs, ping-nodes, etc. 1000x times.

Roel