Visit Open-E website
Results 1 to 10 of 10

Thread: Installing DSS V6 on ReadyBoost-capable USB Flash Drive

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Nov 2009
    Posts
    53

    Default

    @kbro:
    what about installing on a e.g. 4GB SATA DOM? So you dont have to care about reliability of USB devices or USB controllers.
    Just use one SATA slot onboard which should be available cause you're using a H/W raid controller anyway. (you just have to care about power connection, cause a SATA DOM usually needs one)

    So the SATA DOM will be handled like an internal hard disk and 4GB are not too expensive and enough for dssv6 and any further updates.

  2. #2

    Default Long lasting DOM?

    Which SATA DOM would you recommend?
    Does anyone can recommend a 4 GB module, that will last "some years"?

    When I asked Open-E support for a recommendation, they told me this:
    "We recommend to install it on the storage, because we notice that the DOMs and
    USB flash memories has a small life period compared to the storage disks."

    prahn

  3. #3
    Join Date
    Feb 2009
    Posts
    142

    Default

    How about a 40 gb SSD drive connected directly to the SATA port on the mother board. Cheap and dependable. I thought there was very little that gets written to the DSS volume after it boots up so it should not matter. I have had test systems booting off of 2g thumb drives for forever and no problems.

  4. #4

    Default

    In regards to your SATDOM sugestion. That is actually what I wanted to do.
    With my test hardware I was using a whitebox and has power cables available to power the Innodisk SATADOM.

    When production systems arrived and I've noticed this with all the major server vendors is there isn't any spare power leads lying around to power the SATADOM.
    The Innodisk SATADOM uses a molex splitter to go to it's 5v 2pin connector. There simply isn't anywhere to plug the power connector in most of the time.
    Not without making some custom cable to power to take the power source from somewhere else.

    I have used Innodisk SATADOM's in the past and found them to perform well and be very reliable.

  5. #5

    Default

    I just ordered a Half-Slim SATA SSD from Transcend with 4 GB:
    http://www.transcend-info.com/indust...erNo=9&ModNo=6

    This one has wear-leveling, and hopefully it does work reliable for a long time.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •